Bolt Catch Tool
The BCT is comprised of a Custom Made Starter punch and Finishing Punch and half a dozen assembly pins cleverly disguised as tooth picks which have been cut in half. The bolt catch spring and follower should be assembled into the receiver. The Bolt Catch can then be placed in the cut out in the receiver using the assembly pin/toothpick. Resting the Lower Receiver on your bench with the front of the Lower Receiver facing down, place the bolt catch roll pin in the tip of the starter punch. Tap the roll pin in until it almost touches the bolt catch boss on the receiver. At this point, the finishing punch should be used to tap the roll pin home. Finished! If you are wondering why we use a toothpick for an assembly pin , the answer is it works the best
– It won’t scratch the finish on the mag latch ridge and it doesn’t bounce out like a metal one would.
All Rights Reserved | Little Crow Gunworks, LLC